Network
The Network category is used to configure RAS Secure Gateway network options.
To use Site default settings, click the Inherit Defaults option. To specify your own settings, clear the option and set the following:
- RAS Secure Gateway port : By default RAS Secure Gateway listens on TCP port 80 to tunnel all Parallels RAS traffic. To change the port, specify a new port.
- RDP port : RDP port 3389 is used for clients that require basic load balanced desktop sessions. Connections on this port do not support published resources. To change the RDP port on a gateway select the RDP port option and specify a new port. When setting your own port, make sure that the port does not conflict with the standard "RD Session Host Port" setting.
- Broadcast RAS Secure Gateway address : This option can be used to switch on the broadcasting of the gateway address, so Parallels Clients can automatically find their primary gateway. The option is enabled by default.
- Enable RDP UDP Data Tunneling : To enable UDP tunneling on Windows devices, select this option (default). To disable UDP tunneling, clear the option.
- Device Manager port : Select this option to enable management of Windows devices. The option is enabled by default.
- Enable RDP DOS Attack Filter : When selected, this option denies chains of uncompleted sessions from the same IP address. For example, if a Parallels Client initiates multiple successive sessions with each session waiting for the user to provide credentials, Parallels RAS will deny further attempts. The option is enabled by default.