Set-VDIGuestDefaultSettings

Set-VDIGuestDefaultSettings

Modifies default settings used to configure a guest VM.

Set-VDIGuestDefaultSettings [- ConnectionTimeout <uint> ] [- DisconnectMode < VDIDisconnectMode > {KeepCurrentState | Stop | Reset | Suspend}] [- DisconnectTimeout <uint> ] [- EndSessionTimeout <uint> ] [- SiteId <uint> ] [ < CommonParameters > ]

Modifies default settings used to configure a guest VM.

For each setting, the cmdlet has a corresponding input parameter. To modify a setting, specify a parameter and its value.

Default settings are defined on a site level and are applied to a guest VM when it is initially added to a site.

- SiteId <uint>
Site ID.

        Required?                    false

        Position?                    named

        Default value                0

        Accept pipeline input?       false

        Accept wildcard characters?  false

- ConnectionTimeout <uint>
Connection timeout value (in seconds).

        Required?                    false

        Position?                    named

        Default value                

        Accept pipeline input?       false

        Accept wildcard characters?  false

- DisconnectTimeout <uint>
Disconnect timeout value (in seconds).

        Required?                    false

        Position?                    named

        Default value                

        Accept pipeline input?       false

        Accept wildcard characters?  false

- EndSessionTimeout <uint>
End session timeout value (in seconds).

        Required?                    false

        Position?                    named

        Default value                

        Accept pipeline input?       false

        Accept wildcard characters?  false

- DisconnectMode < VDIDisconnectMode >
Disconnect mode.

Possible values: KeepCurrentState, Stop, Reset, Suspend

        Required?                    false

        Position?                    named

        Default value                

        Accept pipeline input?       false

        Accept wildcard characters?  false

< CommonParameters >

        This cmdlet supports the common parameters: Verbose, Debug,

        ErrorAction, ErrorVariable, WarningAction, WarningVariable,

        OutBuffer, PipelineVariable, and OutVariable. For more information, see 

        about_CommonParameters documentation. 

---------- EXAMPLE 1 ----------

Set-VDIGuestDefaultSettings -ConnectionTimeout 300

Sets the default connection timeout.