Previous page

Locate page in Contents

Parallels Client Command Line Parameters

Parallels Client for Windows parameters are available when launching published application and published desktop from the command line.

Parameters

Note

s!='primary server'

Primary Server hostname or IP address.

b!='backup server'

Secondary Server hostname or IP address.

a!='application/desktop id'

Published Application/Desktop ID.

p!='override application params'

t!='port'

Port of the RAS Remote Application Serverconnection.

u!='username'

Username for the user to connect with.

q!='password'

Password for the user.

d!='domain' ignored if user name is in UPN format

Domain name.

l!='0/1' 0 use primary server, 1 user backup server

Specify value  in order to connect either to primary or backup server.

m!='connection mode' (gateway mode = 0, direct mode 1, gateway ssl mode = 2, direct ssl = 3, direct rdp=4)

Specify value for  the connection mode.

o!='0/1' if set to 1 credentials are overwritten with SSO information if available

When set to 1, credentials are overwritten with SSO credentials.

i!='connection alias'

Specify a connection Alias.

c!

Always ask for credentials.

r!

Reconnect if connection is dropped .

Example:

  1. In Command Prompt, go to the location were Parallels Client is installed and run the following command:

    TSClient.exe s!='2008ad1.2x.testing' a!='#50' t!='80' d!='2x.testing' u!='testerjm'q!='123456'  m!='0'

Running the above command will launch Published application with ID92, for user testerjm.