Set-VDIGuestDefaultSettings

Set-VDIGuestDefaultSettings

Modifies default settings used to configure a guest VM.

Set-VDIGuestDefaultSettings [-ConnectionTimeout <uint>] [-DisconnectMode <VDIDisconnectMode> {KeepCurrentState | Stop | Reset | Suspend}] [-DisconnectTimeout <uint>] [-EndSessionTimeout <uint>] [-SiteId <uint>] [<CommonParameters>]

Modifies default settings used to configure a guest VM.

For each setting, the cmdlet has a corresponding input parameter. To modify a setting, specify a parameter and its value.

Default settings are defined on a site level and are applied to a guest VM when it is initially added to a site.

-SiteId <uint>
Site ID.

        Required?                    false

        Position?                    named

        Default value                0

        Accept pipeline input?       false

        Accept wildcard characters?  false

-ConnectionTimeout <uint>
Connection timeout value (in seconds).

        Required?                    false

        Position?                    named

        Default value                

        Accept pipeline input?       false

        Accept wildcard characters?  false

-DisconnectTimeout <uint>
Disconnect timeout value (in seconds).

        Required?                    false

        Position?                    named

        Default value                

        Accept pipeline input?       false

        Accept wildcard characters?  false

-EndSessionTimeout <uint>
End session timeout value (in seconds).

        Required?                    false

        Position?                    named

        Default value                

        Accept pipeline input?       false

        Accept wildcard characters?  false

-DisconnectMode <VDIDisconnectMode>
Disconnect mode.

Possible values: KeepCurrentState, Stop, Reset, Suspend

        Required?                    false

        Position?                    named

        Default value                

        Accept pipeline input?       false

        Accept wildcard characters?  false

<CommonParameters>

        This cmdlet supports the common parameters: Verbose, Debug,

        ErrorAction, ErrorVariable, WarningAction, WarningVariable,

        OutBuffer, PipelineVariable, and OutVariable. For more information, see 

        about_CommonParameters (http://go.microsoft.com/fwlink/?LinkID=113216). 

---------- EXAMPLE 1 ----------

Set-VDIGuestDefaultSettings -ConnectionTimeout 300

Sets the default connection timeout.