Configuring Network Adapters

The Configure Interfaces page (accessible by clicking the Configure Interfaces button on the Traffic subtab of the Network tab of a Hardware Node) enables you to define which network adapters installed on the Node will be taken into account by Virtuozzo network accounting and shaping policies.

This page lists all the network interface cards installed on the Node together with their default (or assigned) bandwidth and IP addresses. You are able to manage these interfaces in two ways:

1. Select or clear the checkbox beside the corresponding adapter to include it in or exclude from being part of network accounting and shaping.
2. Adjust the bandwidth value to your liking. Mind though that it is recommended to leave the default hardware value, or at least not to increase it, because it might interfere with the correct working of Virtuozzo accounting and shaping. Another restriction in modifying this value consists in that you cannot make it lower than the Total Rate value of any class defined for the given interface.

Please send us your feedback on this help page